Paperclip, superglue, and patience. Dab the straightened out paperclip in a tiny bit of glue and stick it to what you want to pull. Again, move slowly and patiently.
If you can take it apart, then it’s possible the other side is open and you just push it out from there. Otherwise, carefully super glue something like a toothpick to it.
If that center part is fairly solid then you could get a small screw (number 4 or 5) and about an inch long and screw it into the material. Then take a pair of pliers and try to pull it out. Do not try to use a drill.
Really depends on the material in the middle. If it’s that soft though you might be able to go just a size bigger than the metal tip to create a press fit and work it out that way. Only need enough out to grab with needle nose
Paperclip, superglue, and patience. Dab the straightened out paperclip in a tiny bit of glue and stick it to what you want to pull. Again, move slowly and patiently.
Heat up a straightened paper lip, stick it into the plastic and wait till it cools. Pull out slowly. Did it myself twice.
It worked! Thank you so much!!!! :DDDDDD
Cheers!
Are there screws visible to allow you to remove the back plate and just completely change out the plug?
there is but the back is just a small circuit board that is glued to the plastic shell inside
If you can take it apart, then it’s possible the other side is open and you just push it out from there. Otherwise, carefully super glue something like a toothpick to it.
If that center part is fairly solid then you could get a small screw (number 4 or 5) and about an inch long and screw it into the material. Then take a pair of pliers and try to pull it out. Do not try to use a drill.
I want to say it would probably just end up free spinning before the screw would tap
Really depends on the material in the middle. If it’s that soft though you might be able to go just a size bigger than the metal tip to create a press fit and work it out that way. Only need enough out to grab with needle nose
I suggest hot glue instead of super glue.
Maybe Vaseline outer ring and hot glue inside broken piece and pull
Kids slime. Stick it up in there & pull it out. Pro tip, use it to clean your phone charging port and speakers.