T O P

In this tutorial, I show everything you need and how easy it is to get one or more Servo Motors working on an ESP32 board with ESPHome and Home Assistant. From just the basics to some advanced settings: Calibration, Initial Position, and control with Home Assistant and automation.

Thanks PGH, you were great!

Sex and adhd

A tip for all the gardeners in this heat

If you were diagnosed later in life, what do you think you could’ve accomplished if you had been diagnosed at a school age?

Thank you duquense light crews

Arts Fest Bridge Vendors & Inevitable Storms

A friendly reminder that the next group of artists start tomorrow at Three Rivers Arts Fest

Love Pittsburgh

Explosion reported at Arts Festival?

Well Done Waterfront Lowe's

Found A Dog (North Side)

I was assaulted at the Smithfield and Sixth bus stop yesterday

Battery operated door “closer”

When does the nagging doubt go away?

"Vivid Unit" - anyone used this?

can’t cast to device on bandcamp

Spotted in East Liberty last week

If anyone in Canada wants a Mazda Bongo Friendee van, check out this guide I put together!

Can’t go back to gas heat after living with a heat pump

Free Review Copies of "Developing IoT Projects with ESP32"

Drive by egging.

How to enter standby mode on MR COOL system to raise and lower ceiling cassette filter?

How much is your gas bill?

Genius Thermostats? Why?

  • By - xtnh

Hi Its Me!

R

xtnh

Subscribe

FIND US ON INSTAGRAM @barcelonachic.com